Got a few problems with the nut on this one. The “G” string is way too low and buzzing dreadfully. Looking closely at the nut, there lies the problem… Yeh, there’s the problem, not fitting well. The best option is to replace it with a new one. I do like good old fashioned bone. Chop […]
Author: George
The Ventures
Now here’s a good looking guitar, I rather like it. As with lots of these Korean guitars, it’s not terribly well built. I’ve seen a lot worse, and I’m sure it can be sorted out. The trem’ is a little high and the owner want’s it blocked to only go down. That’ll make sure it returns to […]
Tanglewood – Sharp Fret Ends
This is a nice guitar, it just has a couple of problems. The biggest problem are the fret ends they’re a little sharp. A minor problem, the jack socket is a little loose. It’s fiddly but the nut on the inside had come loose so it was sticking too far through. It’s that one there. […]
Fender Stratocaster – All new electrics
Here’s a nice looking Strat’. A rather nice upgrade with a new pick-guard and a set of Iron Gear Pickups. It’s also got a problem with one of the saddle height screws. A new set will sort that out. The new pickups are switchable with a Low/High output so I’m going to fit three Push-Push pots. […]
PRS – Re-fret
I don’t quite know why, but PRS have never really done it for me. This one has bits I rather like though, and some that are truly awful! Here’s the problem though, probably the most worn frets I’ve ever come across. They’re beyond a fret-dress, they need to be replaced. A little bit of heat helps […]
Gibson Copy – Complete overhaul
Well here’s an interesting project. Want a Les Paul but can’s afford one? Well I know that feeling. There are some, not too bad, Chinese copies out there. The trouble is the hardware tends to be rather cheap and nasty. A decent one can be a good starting point though. Just replace everything else!! With all […]
Ibanez RG – Service and Setup
Not quite my cup of tea, but a very nice piece of wood… It’s got a common problem, not returning to pitch when you use the trem’. These Floyd Rose Tremolo units can be a little temperamental. It’s also missing a spring, it’s dropped out somewhere apparently. I pretty sure I know where it’ll be….. […]
Gibson SG – Bone nut, service and setup
What a beauty, I’m not sure if It’s a little extreme, but it’s got something. It’s not staying in tune very well mind you, but I think I an see why. Here’s why it’s not staying in tune: With the strings pulling out of the slots in the nut at such an angle, they’ll be […]
Chapman – Service and Setup
I’ve not come across one of these before, rather nice though. This one just needs a service and setup and it’ll be good as new. The biggest problem it’s got is rather self inflicted. Someone took a sticker off it with a Brillo pad, or something equally as bad. It’s left some really deep scratches […]
Columbus – Service and Setup
I do love big semi-acoustics, and you don’t have to spend a huge amount to get a nice one… This one’s pretty good. I’m sure that wiring isn’t original, and its in a rather untidy place. The volume and tone are rather crackly so they need a good clean. While the strings are off its also […]