A kit guitar, just needs finishing off and setting up. It does have some problems though, the frets are very uneven and so causing quite a lot of fret-buzz. The first fret in particular is rather low. That’s a big problem as it means having to take every other fret down to that level. So, […]
Category: Improvements
Hofner bridge and nut upgrade
A rather nice guitar, but with room for improvement. I’ve had this guitar in the workshop before but we couldn’t quite get the intonation properly adjusted as there wasn’t enough space to move the saddles far enough. The nut is also plastic, so while we’re upgrading the bridge, I’ll cut and fit a bone […]
The Story of the Guitar Heroes
What a fantastic night out, watching The Story of the Guitar Heroes in the New Theatre Royal Lincoln. I’ve been struggling for more years than I care to remember to master the Guitar, I could practice for 25 hours a day for the next 200 years and I’ll still not achieve these levels! The playing […]
US Fender Stratocaster – Re-Fret – Final Update
All done. Cut the slots in the nut and finished off with a full setup. Looks even better with strings fitted. To see the re-fret in full click here.
US Fender Stratocaster – Re-Fret 2nd Update
I’ve got a few pre-shaped bone nuts but, alas, none that would fit. The only other blanks I’ve got are a little large and will therefore need a little more work to make one fit. Once I’ve cut it roughly down to size (I’ll get at least 2 nuts from that blank) I’ll use the sanding disk to […]
US Fender Stratocaster – Re-Fret 1st Update
It’s coming along, slowly, but then re-shaping and polishing each fret is rather time-consuming. There really is no other way of doing it but one at a time with finer and finer micromesh cloth. Neck complete. The next step is to make a new nut then bolt the neck back on the guitar. To see […]
US Fender Stratocaster – Re-Fret
Just now and again something really nice comes across the bench. In this case an early 90s US Stratocaster. What’s nice, and almost a little odd is the condition. The frets are badly worn, it really has seen some use. However it’s also been well kept and is in fantastic condition, this guitar really has been loved. Really […]
Fender Stratocaster – Setup
A nice new Stratocaster. Nothing much wrong with it, but the owner just wanted the action lowering and setting up. Starting at the top; the string height over the nut (measured at the 1st fret) was fine. The set in the neck was a rather high (0.023″) so I’ll straighten that out a little. The action height […]
Epiphone EJ-200, Lower action height
Rather a nice acoustic, although the owner wasn’t happy with the action height, It was a little high. Unfortunately, as with most acoustics, it isn’t adjustable. The only solution is to physically reduce the height of the bridge. Grinding down the bridge. The Neck also had a little to much of a curve as well […]
Custom Build
I don’t quite know what to call this one, it started out as a fairly cheap second-hand Washburn, but I’m going to turn it into something rather special. So far I’ve pulled it apart, taken out all the electrics and taken the neck off. I bought a set of machine heads but might not use […]