Wow, this has to be the nicest Strat’ I’ve ever had the pleasure of working on! I’ve had both extremes this week, probably the cheapest and nastiest neck fitted to an old Squire and now this…..Absolutely stunning!! I actually did very little, since it didn’t need much doing but I just wanted to share it […]
Tag: Stratocaster fender
Fender Strat – Floyd Rose setup – completed
Got the screws… all I need to do now is put the springs back and fit a new set of strings… Now for the balancing act! adjusting the tension of the springs against the tension in the strings so that the tailpiece sits parallel with the body. Complete the rest of the setup and it’s ready […]
Fender Strat – Floyd Rose setup
A classic guitar in need of a little TLC… The main reason for getting into this one is that the Floyd Rose is sitting flat on the body, effectively a hard tail. With the rear cover off I can see why, the spring claw is screwed right in… Apart from that the heads on the […]
US Fender Stratocaster – Re-Fret 2nd Update
I’ve got a few pre-shaped bone nuts but, alas, none that would fit. The only other blanks I’ve got are a little large and will therefore need a little more work to make one fit. Once I’ve cut it roughly down to size (I’ll get at least 2 nuts from that blank) I’ll use the sanding disk to […]
US Fender Stratocaster – Re-Fret 1st Update
It’s coming along, slowly, but then re-shaping and polishing each fret is rather time-consuming. There really is no other way of doing it but one at a time with finer and finer micromesh cloth. Neck complete. The next step is to make a new nut then bolt the neck back on the guitar. To see […]
US Fender Stratocaster – Re-Fret
Just now and again something really nice comes across the bench. In this case an early 90s US Stratocaster. What’s nice, and almost a little odd is the condition. The frets are badly worn, it really has seen some use. However it’s also been well kept and is in fantastic condition, this guitar really has been loved. Really […]