Got the screws… all I need to do now is put the springs back and fit a new set of strings… Now for the balancing act! adjusting the tension of the springs against the tension in the strings so that the tailpiece sits parallel with the body. Complete the rest of the setup and it’s ready […]
Tag: Fender
Fender Strat – Floyd Rose setup
A classic guitar in need of a little TLC… The main reason for getting into this one is that the Floyd Rose is sitting flat on the body, effectively a hard tail. With the rear cover off I can see why, the spring claw is screwed right in… Apart from that the heads on the […]
US Fender Stratocaster – Re-Fret – Final Update
All done. Cut the slots in the nut and finished off with a full setup. Looks even better with strings fitted. To see the re-fret in full click here.
US Fender Stratocaster – Re-Fret 2nd Update
I’ve got a few pre-shaped bone nuts but, alas, none that would fit. The only other blanks I’ve got are a little large and will therefore need a little more work to make one fit. Once I’ve cut it roughly down to size (I’ll get at least 2 nuts from that blank) I’ll use the sanding disk to […]
US Fender Stratocaster – Re-Fret 1st Update
It’s coming along, slowly, but then re-shaping and polishing each fret is rather time-consuming. There really is no other way of doing it but one at a time with finer and finer micromesh cloth. Neck complete. The next step is to make a new nut then bolt the neck back on the guitar. To see […]
US Fender Stratocaster – Re-Fret
Just now and again something really nice comes across the bench. In this case an early 90s US Stratocaster. What’s nice, and almost a little odd is the condition. The frets are badly worn, it really has seen some use. However it’s also been well kept and is in fantastic condition, this guitar really has been loved. Really […]
Fender Broken Headstock
Ouch! Bet that hurt…. Luckily it’s a clean break, along the grain and the parts fit together well. The veneer on the face of the head has kept it together. The guy taped it back together to keep it in place which is good. If you ever do break something like this it’s always best […]
Fender Stratocaster – Setup
A nice new Stratocaster. Nothing much wrong with it, but the owner just wanted the action lowering and setting up. Starting at the top; the string height over the nut (measured at the 1st fret) was fine. The set in the neck was a rather high (0.023″) so I’ll straighten that out a little. The action height […]
Telecaster Build – Final Update
Got the Tele finished this afternoon. Not before the neck caused me more grief. Next stage, wire in the electrics. A slightly unconventional wiring with a 4 position switch so that the pickups can be selected singly, in parallel or series. Once the wiring was done It’s the final lap, put the strings back and […]
Telecaster Build – 3rd Update
Added most of the hardware today, even that proved more difficult than I thought. Since the pick-guard is of a very early design there are no holes for the neck pickup screws. I’ve mounted the pickup on two springs with screws directly into the body. Since the pick-guard has to fit over the pickup but under the […]