Epiphone Setup

What a lovely Guitar, just in need of a tweek here and there to get it playing as it should. The frets were good and even so they didn’t need any work for once. Since it’s got a floating bridge I put some low adhesive tape on the body before removing the strings.  That way […]

Bone Nut

This one rather sits at the bottom end of the market, but even so, it should play OK.  This one had a very strange “buzzing” sound.  It’s all down to the cheap plastic nut with its overly slack slots. The only way to cure that is to fit a decent nut.The blank was just a […]

Burns Marquee – Fret Dress and Setup

A lovely guitar, just not quite as good as you would hope… The nut slots have been widened out and then repaired, rather badly.  The only real way to fix that is to replace the nut. Some of the frets are a little un-even, so I’m going to dress them to get a common level. […]

Epiphone Les Paul – Setup

A nice one this, just needs a little TLC.. Nothing much wrong with it really, just needed a little bit of a clean and oil.. followed by a standard 5 point setup.. 1. The neck set… A little high so a turn on the truss-rod… 2. The action at the 12th fret… a little high […]

Guitar Tone Improvement

  Want better tone from your guitar?  Even with good quality pickups you can loose signal through the tone circuits.  Set to 10 there is still some signal going through the variable resistor and capacitor. There is a solution, variable resistors that go to open circuit when at max, thereby disconnecting the tone circuit completely. This is a Stratocaster I upgraded recently.  These […]