I was asked if I could fix a noisy Telecaster, I thought that was the idea! However on listening there was an excessive amount of hum. I though it would be less complicated as you can get to the wiring without taking the strings off. However once I got it open I couldn’t immediately find anything […]
Category: Repairs
Stratocaster wiring problem
Should be a simple job, a crackly Strat’. Always an annoying problem but sometimes difficult to locate. At first I couldn’t really see (or hear) anything wrong, but that’s not really the answer so I opened it up to see what’s inside. The strings are a little worn and there’s always the chance of snapping one, […]
Gibson Flying-V Restoration
Gibson Flying-V Restoration This is bit of a long term job. I started a couple of months ago with a fret-dress but it’s time to start the rest of it. It should be quite simple apart from a couple of sheered off and striped out screw heads. The only way to get that screw out is bit […]
1960s Watkins Rapier – 6th update
I had a little spare time this afternoon so had a bit of a play with the old Rapier. As I’ve not been able to find the proper bridge I decided to fit a “Tuneomatic” one. First thing I need to work out exactly where it’s going to fit so I needed to establish the […]
Encore Strat Setup
This became more of a referb’ than just a setup. A bit of a mess to be honest, a prime example of what can go wrong if you don’t really know what you are doing. The guitar was also rather grubby so the first thing it will need is a good cleanup. At some point […]
Music Room Lincoln
Guitar Surgery Something new, if you want something doing, but are not too sure about it, come in for a chat. I will be available in the Music Room Lincoln between about 10am and 1pm on Sat 25th May for free consultations. If it’s something minor that I can fix on the spot, such as changing a set […]
Gibson Explorer – Service and Setup
A fairly routine job, fit a new set of strings and check the setup. I found a few other bits and pieces that also needed putting right along the way. I’ve never really been a fan of these sort of guitars, one of the inevitable problems is you always end up bashing the ends on […]
Les Paul rebuild
A bit of a bag of nails, this one is going to need quite a bit of attention. The fingerboard is filthy and the frets are badly worn. Neither of the pickups are even connected so a complete re-wire is needed. First job, get the guitar on the jig, dress the frets and clean the […]
Ukulele nut and setup
Another Ukulele that seems a little hard to play. A very high action so the first job is to reduce the action height at the nut. Unfortunately the nut on this one was hollow so cutting deeper slots was not an option. The only choice is to cut a new one from Bone. Start with […]
1960’s Watkins Rapier – 5th update
Now that the neck is finished its time to re-fix it back on the body. Since I’ve filled in the screw holes in the neck I need to make sure the new ones are in the right place. The neck pocket is also a little tired and therefore a bit of a sloppy fit I used […]