Wow, what a monster. I’ve looked at some of these before but I’ve never really tried one out, it just seems so huge! The basic principles for a setup are the same as any guitar, just scaled up a little. It’s also got a problem with the nut. The slots are a little deep so the […]
Tag: Bass Guitar Repair
Fender Precision Bass – Setup
I often get asked if I can set up a Bass guitar. The simple answer is yes, there’s no real difference. Some of the numbers may be a little different but the principles are exactly the same. It’s the same 5 point setup…. No.1 The neck relief. By adjusting the truss-rod. No.2 The action at […]
Water Buffalo Horn Nut
If you need a new bone nut, but want a black one, how about Water Buffalo Horn? It’s not quite as tough as bone but it’s the best natural substance I’ve come across. This Bass needs a new one just because it’s broken. I’ve not got any pre-shaped ones so I’m going to have to […]
Fender Jazz Bass – Setup
What’s in a Bass setup? Much the same as a guitar really, just slightly different settings to allow for the heavier strings… The neck had a little too much set, or curve…. so a tweek of the truss-rod. With the neck flattened out a little it did bring the action at the 12th fret down […]
Fender Precision Bass – Setup
A great looking guitar, just not playing at all well. I didn’t really need to measure the action, more like a step-ladder to reach it! Yeh, that’s possibly the highest action I’ve ever seen, even on a Bass. The bridge saddles were quite low though, and those pickups are rather close to the strings. While […]
Fender Precision Bass – Setup
Another stunning new Fender, just needs a tweek here and there to get it playing at its best. While I was at it I tidied up some of the plastic film left on the pick-guard.. The only way to get it all is to take the knobs off. On with the setup the neck […]
Fender Jazz Bass – New heads and setup
Nice Bass, rather worn machine heads though. Managed to get a rather nice new set from Axesrus to exactly fit the old holes.All that’s needed is a good cleanup….and a lick of oil…Followed by a standard 5 point setup.. No.1 The neck set, starting with it as flat as possible…by adjusting the truss-rod.No.2 the action […]
Milan IV Bass – Setup
This one’s been sitting around for a while, so needs a bit of work to get back into a good playing condition. The machine head posts were quite corroded so that seemed like a good place to start. That’s better.. Next the fretboard, a good cleanup to remove a few years worth of dirt. and then some […]