What a beautiful Guitar, sadly it just doesn’t play quite as well as it should. To get it spot on it needs a fret dress… They weren’t that bad but now they are spot on, just need to be re-shaped….. and polished. Looking good. Just needs putting back together and set up…. starting with the […]
Tag: Electric Guitar Service
Musicman Axis – re-fret
A slightly odd request, a re-fret just to change the feel of the guitar. The neck minus the old frets. Put a slight curve into the new fret-wire. and fit it the old slots. That leaves some very rough and sharp ends…. which need to be filled down evenly. After that each fret needs finishing […]
Fender Jazz Bass nut job
This one had a bit of a buzz so I made a new nut… Unfortunately I couldn’t find a black TUSQ blank the right size so I’ll have to cut down a larger one to fit. Mind you the original blank was the wrong one anyway. The radius of the bottom didn’t fit the neck! […]
Great piece of wood!
I don’t know if I would really want a light wood guitar but this one is really nice. The setup wasn’t bad, just needed a tweek here and there…
Broken Jazzmaster Nut
A fairly simple repair although setting up some guitars is a little more difficult… The bottom of the nut blank didn’t quite fit the slot. It’s a 7½” radius rather than the 10″ of the fretboard. While the strings are off it’s always worth giving the fretboard a good clean and oil. Here is the […]
Vintage Fret Dress
A great looking guitar, now plays as good as it looks… There was nothing very wrong with it, just some slightly uneven frets and a rather high action. First mask off the fretboard and body to protect it… and level the fret tops. Once the frets are re-shaped and polished I put the strings back […]
Yamaha Pacifica setup
How well does your guitar play? This one was almost impossible. However all it needed was a little TLC and it’s a lot better… The frets are also a little uneven, but that’s a whole other job. The set in the neck is huge! You could drive a coach and horses under there! Not sure […]
Hohner Rockwood Re-build, 4th update
With a new neck plate I was able to re-fit the neck. At least it looks like a Guitar again. With the strings fitted I reset the neck set. with a tweek of the truss-rod. Reset the action height. and lastly the intonation. At long last, all back together. To see the project from the […]
BC Rich Bass
The new blank is a little thin but at least it’s long enough. In fact a little too long so I’ll have to take a little off the end. It doesn’t have slots marked so I need to mark them myself….. and start the slots. While the strings are off I gave the fretboard a […]
Hohner Rockwood Re-build, 3rd update
I was going to put the old frets back but they are rather worn so I thought I may as well put new ones in. Clean out the fret slots, although they are already a little deep for the tangs on the new wire. Bend the fret wire into a curve… and tap it into […]