Jay Turser – Fret dress and bone nut

Got handed this one with a “What can you do with this”?  Mainly it’s just missing a nut and one of the bridge pins.  The frets are a little worn as well so I’m going to give them a dress as well.

SANYO DIGITAL CAMERA

It’s seen a lot of action around those open chords..

SANYO DIGITAL CAMERA

Once they’re level, round them off and polish them again.

SANYO DIGITAL CAMERA

Once the frets were done I gave the fretboard a good clean and oil.

SANYO DIGITAL CAMERA

Back to that missing nut.

SANYO DIGITAL CAMERA

I’ve got a blank that’s almost done, so it doesn’t need too much work to make it fit.  A spot of glue to keep it in place this time.

SANYO DIGITAL CAMERA

I’ve also found a nice set of boxwood bridge pins, much nicer than plastic ones.

SANYO DIGITAL CAMERA

With a new set of strings all in needs now is a setup, starting with the neck set.  I don’t need to measure that one, that gap’s huge.

SANYO DIGITAL CAMERA

so tighten up the truss-rod a turn or two.

SANYO DIGITAL CAMERA

It brought the action at the 12th fret down quite nicely as well.

SANYO DIGITAL CAMERA

so all that’s left is the action at the 1st fret.  Rather huge with that new nut.

SANYO DIGITAL CAMERA

So cut the string slots down a lump.

SANYO DIGITAL CAMERA

There it goes, good as new (probably better).

SANYO DIGITAL CAMERA

To see what else I have on offer check out my website www.guitar-george.co.uk

Leave a Reply

Your email address will not be published. Required fields are marked *